We handle heating and cooling work across Shawano and the surrounding area for homeowners, landlords with rental properties, and businesses that cannot afford to leave a space uncomfortable. Every call gets the same attention, whatever the job size.
We work on the full range of heating and cooling equipment, from a furnace that will not light to a heat pump that has stopped transferring heat, from a duct system that has never properly served one end of a house to a complete system replacement when repair no longer makes sense. We are available around the clock, any day of the year, including weekends and holidays.
Call (920) 691-5628 to get the conversation started.
Heating a home through a long northern winter does more than keep the temperature up. Forced-air systems pull moisture out of the air as they run, and by February the indoor humidity in a tightly closed house can drop low enough to cause cracked woodwork, persistent static, and respiratory irritation that nobody connects to the heating system until someone points it out.
A whole-home humidifier addresses that at the source. It ties into the existing furnace and ductwork, controlled by a humidistat that works alongside the thermostat, and treats the whole house rather than one room at a time. The difference is noticeable within days of installation, and it matters most during the months when the system runs hardest.
A standard filter protects the equipment. A whole-home filtration system protects the people in the building. The distinction matters in older homes where the duct system has been in place for decades and the air cycling through it carries more than just dust.
We install air filtration and purification equipment that works through the existing HVAC system. The right option depends on what the air in the property is actually doing, and we walk through that on the call before anything is scheduled.
In some properties, both problems exist at once. Dry air and airborne particles are separate issues with separate solutions, but they share the same delivery system: the duct network and the air handler. Addressing both at the same installation visit is often the most practical approach, and it avoids the cost of a second service call later.
A system that has not been looked at in a few years is not necessarily failing, but it is running on borrowed time. A tune-up covers the heat exchanger, igniter, blower motor, coil condition, refrigerant charge, and airflow through the system. It is the right time to find a worn component before it causes a no-heat call in January, and it gives a clear picture of how much useful life the equipment has left.
A system that starts, runs briefly, and shuts off before the space reaches temperature is telling you something is wrong. The cause might be a dirty filter restricting airflow, a failing limit switch, a refrigerant issue, or a control problem. Short cycling puts extra wear on the compressor and the heat exchanger, so it is worth diagnosing before the underlying problem gets worse.
An air conditioner that runs constantly without bringing the temperature down is usually dealing with a refrigerant issue, a blocked or dirty coil, or an airflow restriction that is preventing heat transfer. In some cases the equipment is simply undersized for the load. The diagnostic works through each possibility and the repair follows from what the system actually shows.
Older homes in this part of Wisconsin sometimes heat with boilers and radiators rather than forced air. Boiler service involves the heat exchanger, the circulator pump, expansion tank condition, and the controls that regulate water temperature and zone valves. A boiler that is losing pressure, making noise, or failing to heat one zone while others work fine is a job we handle.
This covers more than filter changes. When a property has air quality concerns, the diagnostic looks at what the existing filtration is missing, what the duct system is contributing, and what a whole-home solution would involve. The goal is air that is genuinely cleaner, not just a filter that has been swapped out.
An older thermostat that reads the temperature correctly and calls for heat when it should is doing its job. An older thermostat that reads a few degrees off, cycles the system at the wrong time, or cannot hold a setback schedule is costing money every month without announcing itself as the problem.
Modern thermostats and smart controls do more than display a temperature. They learn usage patterns, allow remote adjustment, and give the system more precise instruction than a bimetallic strip ever could. For a home with zoning, the right control makes the difference between zones that fight each other and zones that work together.
Noticing uneven temperatures or a spike in energy bills? A thermostat replacement is sometimes the answer on its own, without any work on the equipment itself. We confirm compatibility with the existing system before anything is installed, and the calibration is verified before we leave.
We are available at any hour, every day of the year. There are no after-hours restrictions and no separate emergency line. A no-heat situation in Shawano in January is a call we take seriously at two in the morning the same way we take it at two in the afternoon.
When you call, the job gets scoped on the phone. You get a clear picture of what the service call covers and what the pricing looks like before anyone comes out. For rental properties with tenants in place, or businesses that have to stay operational, we work around what the property needs. The scope and the timing are settled on the call so there are no gaps in coverage that do not have to be there.
Uneven temperatures across a property are one of the most common complaints we hear, and the cause is almost never the thermostat setting. A room that stays cold when the rest of the house is warm, or a space that never cools down in summer, usually points to one of three things.
A duct that has come loose, a section that was never properly sealed, or a run that is too long and too narrow for the load it is meant to serve will starve one part of a house while the rest of the system works normally. Duct sealing and repair often resolves the problem without touching the equipment at all. We check the duct system when the symptoms point that way.
Some properties were built in stages, or had rooms added after the original HVAC system was sized. An addition that was never properly incorporated into the duct layout, or a finished basement that the original system was not designed to condition, will show up as a room that never reaches the set point. Zoning systems and ductless mini-split installations are both answers, depending on what the layout allows.
Pricing depends on what the system is actually doing and what it takes to address it. The service call covers the diagnostic visit. If a repair is needed, the cost of the parts and the labor involved is confirmed before anything is installed. A job that turns out to be more involved than the initial symptom suggested gets explained and re-quoted before the scope changes.
The things that move a quote are straightforward. What the fault turns out to be, which components need to be reached, and whether repair or replacement is the better answer for the age and condition of the equipment are the main factors. A furnace that needs an igniter is a different job from one with a cracked heat exchanger. A refrigerant recharge is a different job from a compressor replacement.
For a property where the equipment is aging and has needed repeated work, we assess the system honestly and explain both paths. You get the information you need to make the decision, not a recommendation shaped by which answer costs more. If you would rather read than call, our HVAC service list has the detail.
Call (920) 691-5628 and we will walk through what the property is doing and what the visit will cover.
We cover Shawano and the surrounding communities across Shawano County. The neighboring towns we serve regularly include Bonduel, Cecil, Keshena, Thornton, and Legend Lake. If your property is in this part of the county, the call works the same way regardless of which side of a town line you are on.
Residential work, rental properties, and commercial spaces are all covered. Property managers handling multiple units in the area are welcome to call with whatever the building needs. Coverage across the county means the same service is available whether the property is in town or outside it.
Yes. We work on commercial spaces, multi-unit rental properties, and single-family homes throughout the area. For landlords managing units with tenants in place, we work around the occupancy so the property stays covered.
Call (920) 691-5628 and we will confirm what the visit covers before anything is scheduled.
There is no difference in how the call is handled. We are available around the clock, every day of the year, and a no-heat call at midnight on a Sunday gets the same attention as a scheduled appointment on a Tuesday morning. When you call, the job gets scoped on the phone and the visit is arranged from there.
Yes. Whole-home air filtration and purification equipment installed in the HVAC system needs periodic attention to stay effective. That typically means filter or media replacement on a schedule that varies by the type of equipment. We can go over what the specific equipment requires when it is installed or when you call to schedule a visit.
Older homes in this area often have duct systems that were sized for equipment that no longer exists, or layouts that were extended without adjusting the original design. That changes how the diagnostic runs, because the duct condition and the load calculation matter as much as the equipment itself. We work through what the property actually has rather than assuming a standard configuration applies.
It depends on the fault and the equipment. In some cases a short-term measure can keep the system running at reduced capacity while a part is obtained. In others, running the system with a failed component risks further damage. We explain the options honestly on the call so you can decide how to proceed.
If the heating or cooling at your property is not doing what it should, the next step is a single call and a few questions about what the system is doing.
Call (920) 691-5628 and we will scope the job on the phone, confirm the pricing before anything is scheduled, and get the visit arranged around what the property needs. We are available at any hour, any day of the year.
Take a look at our full area list. We also take heating and cooling work in: Pulaski, Seymour, Hobart.
Below is a plain-language look at the heating and cooling work we handle for homes and commercial properties in Shawano and across Shawano County. Each row covers what the service involves, who it fits best, and one practical thing worth knowing before you call. Read through, find what matches your situation, and give us a call for a quote.
| Service | What the Service Includes | Best Suited For | Good to Know |
|---|---|---|---|
| Heating & Furnace Repair | Igniter and heat exchanger check, Blower motor and limit switch inspection, Flue condition review | Any property where the furnace is not starting, blowing cold air, or shutting off early | A cracked heat exchanger changes the repair path significantly. We check that early in the diagnostic rather than at the end. |
| HVAC System Installation & ReplacementMost Popular | Equipment sizing and selection, Full system removal and installation, Ductwork compatibility check | Homeowners and property managers replacing aging or failing equipment | Sizing matters as much as brand. An oversized system short-cycles and an undersized one runs constantly. We assess the space before recommending equipment. |
| Indoor Air Quality & Air Filtration | Whole-home filtration system installation, Air purifier integration with existing HVAC, Filter media selection and setup | Tightly sealed homes where allergens, particles, or odors are a concern | Wisconsin winters mean windows stay closed for months. A whole-home filtration system works through the existing HVAC rather than treating one room at a time. |
Call us at (920) 691-5628 and we will walk you through your options, explain what the visit covers, and get the work scheduled.
(920) 691-5628